GTX-327 SETUP

1. Put the Gtx-327 into setup mode by first having the unit turned off. Hold function key in while turning the unit on. Hold for 5 seconds then release. You are now in the setup mode.
2. Push function key until the following screen appears:
3. 

2. When on this page push cursor until channel 2 input “OFF” is highlighted. If you are using a serial encoder then change port 1 to "Icarus".
3. Press #9 key until this space reads “GPS”. Now press cursor until nothing on the page is highlighted.
4. Next push function key until the below page is displayed.
5. 
6. Push cursor until auto standby “OFF” is highlighted.
7. Push 9 key until this reads “ON”. Push cursor key until cursor no longer appears on page. Turn unit off.

Congratulations you did it!!!