GTX-330 SETUP

Power unit up holding the function key in for 5 seconds. Release the function key and you will find it in the setup mode. The first set of pages is the audio setup. Use the cursor button to highlight the volume and use the 8 and 9 keys to turn up the volume to at least 75%. Cursor over to voice and choose female (if you like). The next audio page will allow you to turn on or off the altitude monitor and count down timer if you desire. Use the cursor button to highlight what you want to change and the 8/9 buttons to change the information.

Use the function key to page to the ARINC 429 page. Cursor over to channel 1 in and turn speed to low and data to GPS/FMS.

On the ARINC out page cursor to channel 2 and set for Garmin w/tis as shown above.

If you have not already done so, page over to the tail number page and enter tail number. You may have to change this from "Hex" to "N" before entering the "N" number.

Congratulations. You are done.